> TO PRESERVE THE QUALITY OF YOUR WATCH > How to use tri-fold type clasp for leather band (Special clasps)

How to use tri-fold type clasp for leather band (Special clasps)

There are 3 types of special clasps as described below;

If the clasp of the watch you purchased is one of them, please refer to the indications.

A Type

  1. Lift up the clasp to release the buckle.

  2. Special clasps A-1 + Special clasps A-1

    Fixed loop

    Movable loop

    Buckle

    Flap

  3. Open the flap.

  4. Special clasps A-2
  5. Remove the pin from the adjustment hole. Slide the band left and right, and reinsert the pin into the adjustment hole at an appropriate length.

  6. Special clasps A-3 + Special clasps A-3

    Pin

    Adjustment hole

  7. Fasten the flap.

  8. Do not push the flap in too hard.

    Special clasps A-4

    When fastening the clasp, insert the tip of the band into the movable loop and fixed loop, and then, securely tighten the clasp.

B Type

Special clasps C-0
  1. While pressing the push buttons on both sides of the flap, lift to open the clasp.

  2. Special clasps C-1 + Special clasps B-1.1

    Push button

  3. Remove the pin from the adjustment hole. Slide the band left and right, and insert the pin into the adjustment hole at an appropriate length. Push the buckle and fasten the clasp.

  4. Special clasps C-2 + Special clasps C-2

    Buckle

    Pin

    Adjustment hole

C Type

Special clasps B-0
Special clasps B-0-1

How to wear or take off the watch

  1. While pressing the push buttons on both sides of the flap, pull the band out of the movable loop and fixed loop. Then open the clasp.

  2. Special clasps B-1.1 + Special clasps B-1.1

    Fixed loop

    Movable loop

    Buckle

    Flap

    Push button

  3. Place the tip of the band into the movable loop and fixed loop, and fasten the clasp by pressing the frame of the buckle.

  4. Special clasps B-1.2

How to adjust the length of the band

  1. While pressing the push buttons on both sides of the flap, pull the band out of the movable loop and fixed loop. Then open the clasp.

  2. Special clasps B-1.1 + Special clasps B-1.1

    Fixed loop

    Movable loop

    Buckle

    Flap

    Push button

  3. Press the push buttons again to unfasten the flap.

  4. Special clasps B-2.2
  5. Pull the pin out of an adjustment hole of the band. Slide the band to adjust its length and find an appropriate hole. Place the pin into the hole.

  6. Special clasps B-2.3 + Special clasps A-2.3

    Pin

    Adjustment hole

    Special clasps B-2.3.1 + Special clasps A-2.3.1

    Pin

    Adjustment hole

  7. Fasten the flap.

  8. Special clasps B-2.4