When the watch shows an abnormal display or does not properly function, or does not move at all or at one-second intervals even after being fully charged, follow the instructions below to reset the built-in IC. Then the watch will resume its normal operation.
Resetting the built-in IC
-
Pull out the crown to the second click.
-
Press and hold buttons A and B simultaneously for three seconds, and release.
-
Push the crown back in to the normal position.
The small seconds hand will stop moving.
For models with screw down crown, please unlock the crown before operating it.
![V192_Preliminary position-1 + Preliminary position-1](/-/media/HtmlUploader/Common/Seiko/Home/instructions/html/SEIKO_V192_EN/assets/fig/V192_Preliminary--position-1_BONDILzrorrkcs.png)
Pull out the crown to the second click.
![V192_System Reset-2 + System Reset-2](/-/media/HtmlUploader/Common/Seiko/Home/instructions/html/SEIKO_V192_EN/assets/fig/V192_System--Reset-2_BONDILxocmekuj.png)
Button A
Button B
Press simultaneously for three seconds.
The small seconds hand will start moving.
If the small seconds hand is moving every two seconds, keep charging until it is moving every second. Charging the battery
![V192_Preliminary position-6](/-/media/HtmlUploader/Common/Seiko/Home/instructions/html/SEIKO_V192_EN/assets/fig/V192_Preliminary--position-6_BONDILafdrekum.png)
-
Adjust the preliminary position of the stopwatch (1/5-second and minute) hands, and then set the time and date.
Adjusting the preliminary position of the stopwatch 1/5-second and minute handsSetting the stopwatch hands (1/5-second and minute hands) to the preliminary position.
How to set the time and dateHow to set the time and date
When the preliminary position of the stopwatch hands (1/5-second and minute) are reset, and time and date are correctly set, the operation of resetting the built-in IC is completed.