There are 3 types of special clasps as described below;
If the clasp of the watch you purchased is one of them, please refer to the indications.
A Type
-
Lift up the clasp to release the buckle.
-
Open the flap.
-
Remove the pin from the adjustment hole. Slide the band left and right, and reinsert the pin into the adjustment hole at an appropriate length.
-
Fasten the flap.
Fixed loop
Movable loop
Buckle
Flap
Pin
Adjustment hole
Do not push the flap in too hard.
When fastening the clasp, insert the tip of the band into the movable loop and fixed loop, and then, securely tighten the clasp.
B Type
-
While pressing the push buttons on both sides of the flap, lift to open the clasp.
-
Remove the pin from the adjustment hole. Slide the band left and right, and insert the pin into the adjustment hole at an appropriate length. Push the buckle and fasten the clasp.
Push button
Buckle
Pin
Adjustment hole
C Type
How to wear or take off the watch
-
While pressing the push buttons on both sides of the flap, pull the band out of the movable loop and fixed loop. Then open the clasp.
-
Place the tip of the band into the movable loop and fixed loop, and fasten the clasp by pressing the frame of the buckle.
Fixed loop
Movable loop
Buckle
Flap
Push button
How to adjust the length of the band
-
While pressing the push buttons on both sides of the flap, pull the band out of the movable loop and fixed loop. Then open the clasp.
-
Press the push buttons again to unfasten the flap.
-
Pull the pin out of an adjustment hole of the band. Slide the band to adjust its length and find an appropriate hole. Place the pin into the hole.
-
Fasten the flap.
Fixed loop
Movable loop
Buckle
Flap
Push button
Pin
Adjustment hole
Pin
Adjustment hole
